Found the perfect ring and ready to get your accurate band size? Follow the guide below to determine the correct band size for you.
The most precise method to figure out your ring size is to visit your local jeweller to have your sizing done professionally and accurately. If this is not feasible, use the ring sizing guide below to help you decide which size is best for you.
This can be done in two ways:
|
Method One:
- Find a ring that already fits the wearers finger well. Make sure you select a ring that is worn on the same finger that you are going to be purchasing the new ring for.
- Measure the INSIDE diameter of a current well fitting ring by placing a ruler across the centre of the ring at the widest part and measuring the diameter in mm.
|
|
Method two:
- Grab a length of string, strip of paper, or tape measure.
- Wrap the string exactly one time around the finger you will wear your ring on. The string should be comfortably tight around your finger, but loose enough to remove as you would a ring.
- Mark where the string meets, and lay the string out on a flat surface.
- Use a ruler to measure the length of the string up to the point you marked, this will give you the the circumference of your ring size.
|
Next, compare the measurements of either the inside diameter or circumference to the sizing chart below to figure out your ring size.
Ring sizes will vary depending on band width. We recommend you select one size bigger if the ring you are purchasing is wider than 5mm, otherwise select the closest size to your measurement for under 5mm bands.
*Please note this is only a guide therefore we cannot be responsible for incorrect ring size determination. Please contact us with any questions regarding ring-sizing at
hello@laylakaisicollection.co.nz
NZD
AUD
USD
EUR
GBP
JPY
